910450

DIVE RITE MANIFOLD - 300 bar

Prior to the 1990's, assembling a set of double tanks required a little patience and a lot of finesse. Manifold center spacing was not standardized and depending on the size of the tanks, getting the proper spacing to prevent the bolts from scraping the tanks or stressing the valves was not easy.

Today, manifolds have become standardized at 8.5-inch (21.6 cm) center-to-center spacing, which gives up to 0.25-inches (6.35 mm) of adjustability so that tank bands will fit properly.

All Dive Rite manifolds use two barrel o-rings to seal either end of the cross-bar, which provides better shock absorption and redundancy compared to the old-style metal-to-metal seal manifolds.

The 300 bar manifold valves have a 180mm isolation crossbar that fits both 7.25-inch and 8-inch diameter tanks. Shock absorbing ribbed rubber knobs are rugged, yet easy to manipulate.

All Dive Rite manifolds come standard for 3500 psi service pressures. The 300 Bar Manifold is designed for use solely with DIN valves.

All Dive Rite manifolds and valves come with Viton o-rings and oxygen compatible lubricants and are Nitrox ready up to 40-percent.

• Ribbed, rubber knobs with stainless steel inserts are tough, yet easy to open/close
• Double barrel o-ring seals provides redundancy and better shock absorption
• Brass with chrome-plated finish gives rugged protection and durability